BlueSR Ultra Steel Soul

版本 v0.1.0·更新於 2026-08-12

A mod that significantly increases the difficulty, with a few surprises included. See README

模組介紹 作者原文

ULTRA STEEL SOUL:

A BlueSR mess of a mod.

This mod is not really fully finished, but it is in a playable state and should therefore provide a fun challenge.

WARNING: i suck at developing or programming or modding using architect (or otherwise) so this project was very much thrown together. I made it for a fun video, but since there has been a lot of interest, i'm uploading it for all of you to try out!

IMPORTANT NOTES:

  • the needle damage and Mask amounts have to be configured separately in the Debug Mod. Do note that there is a known issue with needle scaling. I'd also recommend the Debug Mod in case you get softlocked or something along those lines.
  • The Awakened Grand Mother Silk Mod used in the video is NOT included in this modpack, and needs to be downloaded separately, as it is not compatible with AssetHelper (one of the dependencies for architect). Therefore, before you fight grand mother silk, you must exit the game, turn off AssetHelper and enable Awakened GMS.
  • Known Softlock after defeating Tormented Trobbio. Uh, i couldnt really fix it because im stupid. Uh. Good Luck. just boot up the game and noclip past or something idk.
  • The mist route exists but isn't really developed. Phantom has nothing cool going for them (aside from that sick organ ofc)

have fun and good luck!

Dependencies:

Architect

AssetHelper

Debug Mod

Pharloom's Glory

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

cometcake575-Architect

檔案與校驗

檔案名稱
BlueSR_Ultra_Steel_Soul-0.1.0.zip
檔案大小
19.3 MiB