WFBern Weize Series

版本 v1.0.0·更新於 2026-09-18

Experimental Swiss assault rifle

模組介紹 作者原文

W+F Bern WEIZE Series

The WEIZE series was a family of experimental Swiss assault rifles developed by Waffenfabrik Bern during late 70s as means to replace its aging STG 57. The design is fairly straight forward, using rotating bolt locking system and mixture of plastic and stamped steel. This is also the time where the experimental 6.45x48mm XPL ammo comes by, a middle ground between 5.56mm and 7.62mm NATO.

There are 4 different configurations, with standard rifle length, the E22 and C42 comes with longer barrel and bipod, while the "MP" series is the E21 and C41, with just shorter barrel and no bipod.

Features

  • 4 different configurations of the WEIZE series
  • Chambered in either 6.45x48mm XPL experimental ammo or standard 5.56x45mm NATO
  • Also comes with 20 and 30 rounder
  • Features the ability to mount muzzle devices, STG57 bayonets and its bespoked scope, as well as hidden rails
  • Can be found in Firearm > Carbine or Assault Rifle

Note

  • The rifle uses a slightly different bolt release system, to avoid accidental bolt closure, user needs to slap the bolt release hard at an angle to represent the correct angle OR grab the bolt release and press any buttons!

Model from Akinaro, with support from Marcus and SomeGundamFan!

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

devyndamonster-OtherLoadercityrobo-OpenScripts2Volks-645x48mmXPL_Ammo

檔案與校驗

檔案名稱
WFBern_Weize_Series-1.0.0.zip
檔案大小
37.7 MiB