TriggerguardLaserModule
A triggerguard attachment you can put onto any firearm with a muzzle attachment point. Controls in README.
截圖 共 1 張
模組介紹 作者原文
Triggerguard Laser Module
A triggerguard attachment you can put onto any firearm with a muzzle attachment point.
Controls
Grab the attachment while attached to a gun and hold down the trigger to move it.
Depending on how far you press the trigger down it will move faster or slower with your hand, allowing you to precisely put it where you want to.
The same applies for the clamping mechanism. It's trigger is a little bit behind the actual clamp for easier grabbing. Notice how the screws are turning in and out as you move the clamp! Wonderful!
Press up on the touchpad (or the BY button in streamlined) to toggle the laser as with any other vanilla laser attachment.
Changelog
v1.0.1 Fixed some issues regarding muzzle effects by no longer making the laser a muzzle device but a normal attachment.
v1.0.0 Initial release.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：