Minebea PM9
Uzi if it wasn't
截圖 共 2 張
模組介紹 作者原文
Minebea PM9!
Adopted in 1999, the PM-9 was intended for non-frontline personnel such as vehicle drivers, artillery crews, and certain special forces units where a full-size assault rifle would be unwieldy.
While widely used by the Japan Air and Maritime Self-Defense Forces for base security and personal defense, the Japan Ground Self-Defense Force began seeking a replacement, such as the H&K MP5, due to the PM-9's high cost and outdated design.
Featuring rails on the barrel and foregrip
2 attachable stock positions on the pistol grip and rear upper and a special stock that slips under the rear part of the receiver
Model by 8sianDude
special thanks to Iqsbascizzz and Volks!!!!
Changelog
1.0.0 >>>>>>>> RELEASE!
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：