Mil MI24P Attack Helicopter
Flying IFV brrrrrrr.
模組介紹 作者原文
Mil MI-24P Attack Helicopter
Before taking off
[Important!!!] Check if your object handling method is set to floating instead of direct, physical stick won't work with direct control mode.
Make sure you are in the center of your playing area, a recenter is recommend.
How to fly it?
Click the red lever behind the throttle to start up.
Once the engine is on, grab the throttle and stick then you are ready to go, press left joystick to use rudder.
Other features
Click left panel to toggle fan (you can poke it to stop it lol).
Click the 'X' shaped button behind the seat to toggle rear doors.
Click the 'X' shaped button in the back seats to toggle Seats for troopers.
When rear doors opened, click the 'X' shaped button near the left door to toggle MG.(To use the MG, you need to have Helicopter Playerbody mod on and enabled)
While holding the stick, joystick left and rightward to shoot rocket and cannon.
Only the CP/G pilot can use the laser guided missile by clicking the handle on their right side.
Notice that when the rear door is opened, the inner B-8 pod will be disabled.
Notice
Don't land with a high vertical velocity or the tail may break.
Also be aware of enemy AA fire.
MI-24 is really not some easy heli to fly (since it leans to the right), so pls be patience and practice more.
Due to H3MP sync issue, I won't promise that it can function well in multiplayer so be careful of desync and errors.
Change Log
1.0.0 Added MI-24P in Tools&Toys----->Utilities.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：