Mikoyan MIG29A
Just can't fly too far away...
模組介紹 作者原文
Mikoyan MIG-29A
Bingo fuel.
How to fly ( IMPORTANT!!! )
1, First Climb up the ladder and click lower back of the seat.
2, Wait 5 seconds to adjust height.
3, Click the end of the ladder to remove it along with wheel chocks.
4, Grab the canopy handle on the left and push forward to close the canopy.
5, Click the 7 toggle buttons on the rear right vertical panel (or the lever to toggle all of them at once).
6, Click Start button on the right horizontal panel.
7, After the engine is started up, Click Flaps on the left horizontal panel to lower them.
8, Click the lever on the stick to release hand brake.
Flight Control:
Grab the throttle and Stick to fly, Stick trigger to shoot cannon, move joystick on the throttle controller to steer on the ground. joystick rearward to brake.
Click the red lever between legs to eject.
How to read the SPO-15
The OUTTER YELLOW blubs with numbers shows the front hemisphere's incoming degrees of the Main threat.
The GREEN blubs under them are the incoming direction of the second threat.
The INNER YELLOW square blubs shows the aggressive level of the main threat.
The MIDDLE RED Circle shows the threat state. (Static light means Radar Locked, Sparkling light means Missile Launched).
The MIDDLE YELLOW Half-Circle shows whether the threats come from above or below. (Unimplemented so far).
The two LOWER YELLOW blubs with arrows shows the rear hemisphere's incoming degrees of the Main threat.
The GREEN blubs above them are the incoming direction of the second threat.
The LOWER YELLOW Squares shows the radar threat type. (Unimplemented).
Notice
The plane may glitch heavily
Change Log
1.0.0 Added MIG-29A in Tools\&Toys---->Utilities.
1.1.0 Added SPO-15 to warn of SAM missile incoming.
1.1.1 Improved SPO-15 logic to make it more readable.
1.1.2 Health Bar and QBSlot will auto hide when in seat, also changed SPO-15 detecting method.
1.2.0 Added backup compass, and changed to a much more detailed livery; more likely get hit by SAM due to flight model change; Added dark filter for the HUD, click the lever next to it to toggle; Added three togglable rear mirror.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：