Lada2106
Never too many Lada
模組介紹 作者原文
Lada 2106
"Must go faster, faster, must go faster!" ---------Jester
How to drive
You click open the rear trunk, shovel everything you need into it, open the door, and click to get into the driver seat.
AFTER GETTING INTO THE SEAT, SIT STILL AND WAIT 3 SECONDS FOR THE CAR TO ADJUST YOUR HEIGHT!!!
Grab the key hole near the steering wheel and turn 90 degrees to start up the engine, then grab and hold trigger to release the hand brake.
Grab the drive rot and hold trigger to shift gear,
grab the steering wheel and press trigger to set out your crazy journy.
Blyat you forgot to close the rear trunk door!
Notice
To use the car in H3MP without player collide with the vehicle and glitch it out, click the fuel tank cap on the right side of the car to toggle colliders, then it should disable Player's collision with the car.
Change Log
1.0.0 Added Lada 2106 in Tools\&Toys-------->TippyToy
1.1.0 Added engine sync in H3MP, but still only the person who spawned the car first can drive it.
1.1.1 Added functional back storage area.
1.1.2 Tweaked seat pos.
1.2.0 Brand New interaction method!
1.2.1 Added H shift limit and much more stable seat.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：