EscapeModpack

版本 v1.0.0·更新於 2024-01-18

Multiplayer escape modpack made for Takedown Terry.

模組介紹 作者原文

Description

  • This modpack was made for Takedown Terry.
  • It is fully multiplayer compatible, and made with reliability and realism in mind.
  • For information about gameplay and recommended settings, read Takedown Terry's description.

After having installed everything, you can (should) remove Escape Modpack from your mods list. As mods update, Escape Modpack's dependencies will fall behind. Don't pay attention, update all mods.

Note: We have limited control over H3MP, Supply Raid, and other mods. Use the tools at your disposal to restore balance to the world when jank happens.

Instructions (super simple)

  • Grab "config.zip" in the mod's folder, and unpack it in.
  • Customize your height in the PlayerFootsteps config.

While in-game, we highly recommend:

  • Setting a different Safehouse map than your buddies.
  • For your buddies to loot your dead body, you'll have to fly back ("Set Spectator" in the wrist menu) and drop your stuff manually. AFAWK it's the only way.

Good luck out there

If you have any feedback, ping @morbo or @goodnightleo on H3VR Homebrew Discord.

安裝與使用 安裝：BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
  2. 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝，否則該模組不會生效：

Arpy-ArpysBackpacksShampooh-Better_Bullet_Crackscityrobo-Brighter_FlashlightsNikpo-CTS_Packsirpotatos-DrPotatosHomeRemediesAndrew_FTW-FTW_Arms_Modular_HelmetsAndrew_FTW-FTW_Arms_Patches_PlusNGA-GunCaseFix

檔案與校驗

檔案名稱
EscapeModpack-1.0.0.zip
檔案大小
96.0 KiB