Bell UH1H Utility Helicopter
I'm not fortunate son
模組介紹 作者原文
Bell UH-1H Utility Helicopter
Probably the most iconic utility helicopter around the world.
Before taking off
Make sure you are in the center of your playing area, a recenter is recommend.
How to fly it?
First lick the doors to open them, then CLICK the seat's buttom or back to get into the helicopter (pilot seat is at the right side), after that, wait 5 seconds with looking straight at front to let script adjust your seat height.
To cold start, turn on battery, generator and non-ess bus button on the top panel, then click the head of collective pitch handle to start the apu, when the apu is turning on, click the fuel pump button on the bottom middle panel. Then wait for engine warm up and you are good to go.
Grab the stick and throttle to take off.
The UH-1H didn't have weapons attached and it's an old model without any flight assists.
Change Log
1.0.0 Added UH-1H in Tools\&Toys------>Utilities.
2.0.0 Totally reworked the plane with current script.
2.1.0 Added bunch of new features and COPILOT INPUT FOR H3MP!!!!
2.1.1 Tweaked for better flight experience.
2.2.0 Added weapon sync and cross input for both pilot and copilot!.
2.2.1 Tweaked cold start waggle effect, updated icon.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：